BuddeMix Stirring System 1 - 4

BuddeMix Stirring System 1 - 4
BuddeMix Stirring System 1 - 4BuddeMix Stirring System 1 - 4    
This novel stirring system has been conceived to mix low viscosity fluids as well as highly viscous media at slow speeds. Its special design creates inherent dynamic currents to produce perfectly homogeneous mixing results in very little time. Additional components like baffles, bottom bearings, etc. are not needed.

Advantages at a glance:
  • suitable for low to highly viscous fluids
  • stirs media containing solids and fibres without any difficulty
  • gentle, low-shear stirring, due to slow stirring speed
  • constant product temperature, with no heating effect
  • short mixing times as the entire contents of the container are agitated
  • no air addition, no foaming
  • no baffles required
  • low gear wear due to balanced forces
  • minimal power consumption thanks to low speeds and short operation times
  • easy cleaning
  • material no. 1.4404

Particularly for potentially explosive atmospheres:
  • a single stirring zone, near to the container base, ensures easy mixing of settled residues, e.g. in flow-through mixing containers
  • no baffles required, thus no additional sources of ignition
TypeBuddeMix 1
Ø agitator mm60
Ø agitator shaft mm10
Length mm350
Material No.1.4404
PK1
Cat. No.06302613
-
TypeBuddeMix 2
Ø agitator mm80
Ø agitator shaft mm10
Length mm350
Material No.1.4404
PK1
Cat. No.06302633
Lieferzeit ca. 10 Arbeitstage
TypeBuddeMix 3
Ø agitator mm120
Ø agitator shaft mm10
Length mm550
Material No.1.4404
PK1
Cat. No.06302632
Lieferzeit ca. 10 Arbeitstage
TypeBuddeMix 4
Ø agitator mm150
Ø agitator shaft mm10
Length mm850
Material No.1.4404
PK1
Cat. No.06302631
Lieferzeit ca. 10 Arbeitstage
TypeBuddeMix Mini 30
Ø agitator mm35
Ø agitator shaft mm8
Length mm350
Material No.1.4404
PK1
Cat. No.09767658
-
TypeBuddeMix Mini 40
Ø agitator mm46
Ø agitator shaft mm8
Length mm350
Material No.1.4404
PK1
Cat. No.09767657
-
Customised shaft length possible. Fine polishing Ra 0.6 to 0.8 µm and/or material certificate available on request.